Description
Resuflor HB (formerly known as Resucoat HB) is a two-pack, high performance floor coating, providing a hygienic, easy-clean and hard-wearing resin floor system.
- Pack Sizes: 5kg and 25kg
Sherwin WilliamsResuflor HB – formerly Resucoat HB
Pack Sizes:
5kg and 25kg
Product Description;
Incorporating technology based on high solids epoxy resin technology which is designed to provide a tough and durable floor protection finish in a variety of thicknesses and colours for a wide range of applications, Resuflor HB will provide a smooth gloss finish to which anti-slip aggregate can be added if required.
Product Benefits;
- Single coat application up to 500 microns
- Wide range of colours available
- Seamless
- Hygienic
- Easy to clean
- Chemical resistance
Yield;
5 kg will cover *17m2 @ 200 microns wet film thickness.
*Coverage rate is calculated based on a sealed and smooth surface and may vary based on the substrate roughness and other conditions.
Standard colours;
RAL 7035, RAL 7038, RAL 7040, RAL 7042, RAL 7043, RAL 6002, RAL 5017,
RAL 1032, RAL 3020, RAL 3011, RAL 9011, RAL 9003
Also available in a wide range of non-standard colours by clicking here
Product Advantages;
- High-build finish
- High solids
- Hygienic and easily cleaned
- Good colour stability
- Excellent slip resistance with the inclusion of selected aggregates
- Excellent high gloss finish
Recommended areas of use;
- Food processing and beverage areas
- Chemical plant rooms
- Engineering workshops
- Automotive and aviation areas
- Factory unit floors
- Warehouses
- Excellent for all demarcation and walkway areas
Product Application;
Resuflor HB is easy to apply by roller and paint brush to create a seamless, hard wearing and hygienic floor finish.
The ambient temperatures of the areas should not be allowed to fall below 15C throughout the application and the curing period, as this could have an adverse effect on the appearance and colour of the system. Surface temperature must be above 10C. Where possible it is recommended that the application area is heated to a minimum temperature of 15C ideally to allow the ambient and substrate temperature to stabilise prior to installation.
Mixing;
Pre-mix the coloured base component to a uniform consistency then mix the entire contents of the base with the hardener. If a separate mixing bucket is being used mix thoroughly ensuring all contents of both components are removed from the buckets supplied. Mix using a slow speed electric mixer for approximately two to three minutes until the two components have fully combined. The mixed unit should be applied immediately by roller or brush with a consistent procedure. Floor areas should be cross-rolled to ensure even application and to minimise roller marks
Contact Us;
For further advice regarding the use of this product, technical support or a quotation please contact us.
Reviews
There are no reviews yet.