Natural Cement – WaterStop

Description

Natural Cement’s WaterStop is a naturally fast setting and fast curing natural cement based material. It is resistant to chloride penetration, is Reg. 31 approved for contact with drinking water, and is not affected by sea water. Approved to Reg. 31 for contact with drinking water.

• Yield: Generally, 1 x 5 kg bag of WaterStop mixed with 1.9 litres of water will produce around 2 litres of mortar

• Pack Size:5 litre tub

Product Description

WaterStop is a fast setting material based on a potable water approved natural cement, it is an environmentally friendly, fast setting, water stopping material that at 20c starts to set in 90 seconds and is totally set in 2 minutes. It is also Reg.31 approved for contact with drinking water.

The product only requires to be added to water and mixed for two minutes (see mixing instructions for further details) and provides a waterproof barrier. It can be used in cold & wet conditions, sets under water and from a minimum of 1 mm can be, if required, built up layer on layer to any thickness.

Recommended Uses

• Chemical Resistance

• Reg.31 Approved Products for contact with drinking water

• Concrete Repairs

• Tanking

• Sealing leaks

• Stopping ingress of water

Sectors

• Utilities

• Construction

• Civil Engineering

• Railways

• Sea Defence

• Mining

• Water

Product Advantages

• Fast controllable set

• No curing membrane necessary

• Waterproof

• Set under water

• Resistant to chemicals

• Potable water approved

• Safe with drinking water

• Safe with aquatic life

• Can be mixed with seawater

• Resistant to seawater

• Very low shrinkage

• Low Reactivity (No Conversion)

• High Alkalinity (No Rusting)

• Excellent Adhesion

• Fine compact surface

• Sets down to Zero degrees

• Starts to set in 90 seconds at 20c

Natural Cement Product Range

NATCEM 35	NATCEM AC	NATCEM D	NATCEM DW
NATCEM Tank	NATSEAL	Grout 105	CWG Grout
LUL RapideSet	ShotCrete AS90	ShotCrete 430F	ShotCrete 437F
ShotCrete 513	ShotCrete 530	TrackCrete	WaterStop

Surface Preparation

Please refer to the product data sheet or contact us for advice.

Mixing

Please refer to the product data sheet or contact us for advice.

Application

Please refer to the product data sheet or contact us for advice.

Cleanup

WaterStop should be removed from tools and equipment with water immediately after use.

Storage

WaterStop is packaged in 5 kg units in a sealed polythene bag inside a plastic sealed tub. If stored in dry conditions it will last for at least twelve months.

Precautions

We strongly recommend the use of gloves, goggles and mask. A full material safety data sheet relating to this product is available – please contact us to request a copy.

Contact Us

For further advice regarding the use of this product, technical support or a quotation pleasecontact us.